Hyundai HL955 Manual page 191

⑨
Mount inner installer (S) onto the disk
carrier.
Install disk (1), compression spring (2),
support shim (3) and L-ring (4).
※
Installation position support shim and
L-ring see TM161.
Inner installer : see figure TM160
⑩
Preload compression spring by means of
assembly aid (S1) and pressure piece
(S2), until L-ring has engaged into the
annular groove.
Assembly aid (S1)
Assembly fixture (S＋S2) 5870 345 124
(Inner installer and pressure piece)
※
It is always necessary to mount a new
L-ring.
Disk carrier with piston retraction :
1 Washer
2 Compression spring
3 Support shim
4 L-ring
5 Disk carrier
6 Drain valve (piston)
7 Piston with O-rings
※
Different clutches (disc arrangements
with relevant disc clearance) can be
installed, depending on the par ts
manual.
※
The actually installed clutch and disc
arrangement must be taken from the
corresponding parts manual.
※
Figure no. : TM162 and TM163 illustrates
the different disc arrangements.
5870 345 088
3-135
4
2
S
S2
1 2
5
6
7
3
1
7609ATM159
S1
7609ATM160
3
4
7609ATM161