Hyundai HL955 Manual page 254

21
Mount stud bolts (1).
※
Wet screw-in thread with loctite (type No.
243).
·Tightening torque (M8/10.9×25) :
1.53 kgf·m (11.1 lbf·ft)
Place seal (2) and duct plate (3) at the
housing rear par t until contact is
obtained.
※
Use assembly grease.
22 Fix duct plate (1) by means of Torx
screws (2) and hexagon nuts (3).
·Tightening torque (M8/10.9×30) :
2.35 kgf·m (17.0 lbf·ft)
·Tightening torque (M8) :
2.35 kgf·m (17.0 lbf·ft)
Mount screw plug (4) with new O-ring 13
×2.
·Tightening torque (M16×1.5) :
3.06 kgf·m (22.1 lbf·ft)
Socket wrench TX-40
23 Mount compression spring (4), piston (3)
and switch (2) with new O-ring 13×2.
1 Filter differential pressure valve
2 Switch with O-ring
3 Piston
4 Compression spring
·Tightening torque :
3.06 kgf·m (22.1 lbf·ft)
24 Fit two adjusting screws.
Adjusting screws
Mount sealing plate (1) and electro-
hydraulic control unit (2).
※
It is not permitted to reassemble the seal
plate after opening the threaded joint
shift unit/gearbox housing.
In case of repair it is always necessary to
mount a new seal plate.
1
2
3
4
5873 042 004
5870 204 063
3-198
1
2
3
1
2
3
4
S
2
1
7609ATM391
7609ATM392
7609ATM393
7609ATM394