Hyundai HL955 Manual page 319

④
Position preassembled brake housing on
the output shaft.
※
Special tool
Lifting chain
Eyebolts
⑤
Insert sealing elements (arrows) into
annular grooves of brake housing paying
attention to installation position and
arrangement - in this context refer to
figure 7577AAXR028.
Guide ring installation : Guide ring installation :
Clean annular groove of brake housing
with spirit.
Then insert guide ring into annular
groove - Ensure an exact contact
position of the whole guide r ing
circumference - after wards stick guide
ring with glue (Loctite no. 415) on its
endpoints.
※
Ensure a correct installation position of Ensure a correct installation position of
the guide ring - Endpoints of guide ring the guide ring
to be in 12 o'clock position in the axle
installed in the machine (radial position in
brake housing - area of brake oil supply
and vent hole).
1 Brake housing
2 Guide ring
3 Support ring
4 Grooved ring
5 Grooved ring
6 Support ring
5870 281 047
5870 204 071
3-263
2
3
4
5
6
1
2
3
4
5
6
7577AAXR036
7577AAXR037
7577AAXR038