Hyundai HL955 Manual page 295

Reassembly of shaft seal (figure Reassembly of shaft seal (figure
AX134~136) AX134~136)
23
Loosen the slotted nut and pull the input
flange from the input pinion.
Slotted nut wrench
Clamping device
24
Mount the shaft seal with the seal lip
showing to the oil chamber.
Driver tool
※
The exact installation position of the
shaft seal is obtained when using the
specified driver tool.
※
Wet the outer diameter of the shaft seal
with spirit directly before installation and
fill the space between seal and dust lip
with grease.
25
Insert input flange and finally tighten by
means of disk and slotted nut.
·Tightening torque :
122 kgf·m (885 lbf·ft)
Slotted nut wrench
Clamping device
※
Cover the thread of the slotted nut with
loctite (type no. : 262).
5870 401 139
5870 240 002
5870 048 233
5870 401 139
5870 240 002
3-239
7609AAX134
7609AAX135
7609AAX136