Hyundai HL955 Manual page 333

4) 4) REASSEMBLY - INPUT / DIFFERENTIAL EASSEMBLY - INPUT / DIFFERENTIAL
(1) (1) Input Input
1 Axle drive housing
2 Input pinion
3 Tapered roller bearing
4 Shim for contact pattern (bevel gear set)
5 Spacer ring (bearing roll.torque/pinion
bearing)
6 Tapered roller bearing
7 Shaft seal
8 Protection plate
9 Input flange
10 Disc
11 Hex nut
12 Bearing flange (only for axle version with pivot bearing)
13 Axle housing/part I
14 Axle housing/part II (crown-wheel side)
※
Depending on the version - crown wheel and bevel pinion may be mounted as a bevel gear set
(for production reasons, crown wheel and pinion are paired and show an identical pairing number
- see figure 7577AAXR086) or as single parts - the respective version has to be taken from the
specification of the corresponding spare parts list.
If a bevel gear set is specified, the crown wheel must only be replaced together with the pinion.
Only for assembly of new parts or if
disassembled :
①
Mount O-ring on axle housing/part I and
install axle drive housing - pay attention
to radial installation position!
·Tightening torque (M 18×1.5/10.9) :
39.8 kgf·m (288 lbf·ft)
14
1
12
10
11
3-277
2
13
3
4
5
6
7
8
9
7577AAXR083
7577AAXR084