Hyundai HL955 Manual page 299

④
Insert both bearing outer rings (see
arrows) into the brake housing until
contact is obtained.
⑤
Insert the premounted brake housing by
means of the lifting device over the
output shaft until contact is obtained.
※
Before clamping the seal rings (slide ring
seal) to installation dimension, clean the
sliding surfaces and apply an oil film.
We recommend to use a leather cloth
soaked with oil.
⑥
Insert back-up rings and grooved rings
into the annular grooves of the brake
housing (see arrows).
※
Pay attention to the installation position;
please also refer to sketch, page 3-244.
⑦
Clean the annular groove of the brake
housing with spirit.
Then insert the guide ring into the
annular groove (see also the following
sketch) and fix it with loctite (type No. :
415) at its extremities (see arrows).
※
The full circumference of the guide ring
must be in an exact contact position.
※
Upon installation the orifice of the guide
ring must show upwards (12 o'clock).
3-243
7609AAX147
7609AAX148
7609AAX149
7609AAX150