Hyundai HL955 Manual page 286

⑨
M o u n t o u t e r a n d i n n e r d i s k s i n
alternating order, starting with an inner
disk.
The installation clearance of the internal
parts is corrected by mounting outer
disks with different thicknesses.
The difference in thickness between The difference in thickness between
the left and the right disk package the left and the right disk package
must only be 0.1 mm at maximum. must only be 0.1 mm at maximum.
Determine the installation clearance Determine the installation clearance
0.2~0.7 mm 0.2~0.7 mm
⑩
Measure dimension I, from the mounting
face of the differential housing to the
plane face of the outer disk.
Dimension I e.g. . . . . . . . . . . . . . 44.30 mm
⑪
Measure dimension II, from the contact
face of the outer disk to the mounting
face on the housing cover.
Dimension II e.g. . . . . . . . . . . . . 43.95 mm
CALCULATION EXAMPLE :
Dimension I . . . . . . . . . . . . . . . . 44.30 mm
Dimension II . . . . . . . . . . . . . . . - 43.95 mm
Difference = disk clearance = 0.35 mm Difference = disk clearance = 0.35
※
Any deviation from the required
installation clearance is to be corrected
with corresponding outer disks (s = 2.7, s
= 2.9, s = 3.0, s = 3.1, s = 3.2, s = 3.3 or
s = 3.5 mm), taking care that the
difference in thickness between the left
and the right disk package must only be
0.1 mm at maximum.
mm
3-230
7609AAX105
7609AAX106
7609AAX107