Setting The Menu To Be Shown When The Menus Are Started; Selecting The Mouse Button Used For Adjusting The Knob Parameters - Sony MVS-6000 User Manual

Setting the Menu to be Shown When the Menus Are
Started
1
2
Note
To enable this setting, the initial state of the control panel when powered on
must be set to one of the following.
• Set to Resume mode
• Set to Custom mode, with "User" selected in the <Setup> group.
For details of these settings, see "Selecting the State After Powering On (Start
Up Menu)" (page 24).
Selecting the Mouse Button Used for Adjusting the
Knob Parameters
In the Panel >Maintenance menu, press either of the following buttons in the
<Mouse Sliding Control> group.
Left Button: Dragging the bar while holding down the left mouse button
Right Button: Dragging the bar while holding down the right mouse button
Note
When Left Button selected, even pressing one of the knob parameter buttons in
the menu control block does not display a numeric keypad window.
122
Screen Saver and Other Settings (Maintenance Menu)
In the Panel >Maintenance menu, press [Initial Menu Set].
A popup window appears.
Enter the page number of the desired menu.
The next time the menus are started, the menu specified by this number
appears.
adjusts the parameter assigned to the knob.
adjusts the parameter assigned to the knob.