Replacing The Microsd Card - Fujitsu PRIMERGY CX2550 M6 Upgrade And Maintenance Manual

10.7.5

Replacing the microSD card

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server node" on page
▶ Remove all external cables from the server node.
▶
"Removing server nodes from the server enclosure" on page
▶
"Removing a riser module" on page
Replacing the microSD card
▶ Remove the Dual microSD 64GB Enterprise, see
microSD 64GB Enterprise" on page
▶ Remove the defective microSD card from the Dual microSD 64GB
Enterprise.
Proceed as described in the following:
▶ To eject the defective microSD card, gently push it in and then let go, see
Figure 173.
▶ Pull the microSD card straight out of its slot.
CAUTION
(not valid for Europe, Middle East, India and Africa)
The microSD card contains customer information.
▶
After removing the microSD card, hand the card over to the
customer.
▶
If the customer requests disposal of the defective microSD
card, proceed as follows: Using a pair of side-cutting pliers,
cut the microSD card in half.
49.
251.
Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
41.
45.
"Removing the Dual
45.
255