Set Up Data Mover Worksheet - EMC VNX VG2 Setup Manual

EMC CONFIDENTIAL
Setup Worksheets
Set up Data Mover
worksheet
284 EMC VNX VG2/VG8 Gateway Configuration Setup Guide
The Set Up Data Mover step configures the Data Movers. This step is repeated for
each Data Mover (DM) in the system. This step does not run if a file system has
already been created on the system.
Note: This appendix uses the terms blade, Data Mover, and server to refer to the same device.
You will need the following information:
Data Mover Role
Data Mover 2 (server_2):
Data Mover 3 (server_3):
Data Mover 4 (server_4):
Data Mover 5 (server_5):
Data Mover 6 (server_6):
Data Mover 7 (server_7):
Data Mover 8 (server_8):
Data Mover 9 (server_9):
Standby DM
❑ ❑ ❑
None server_2 server_3
❑
server_8 server_9
DM Failover Policy
Data Mover 2 (server_2):
Data Mover 3 (server_3):
Data Mover 4 (server_4):
Data Mover 5 (server_5):
Data Mover 6 (server_6):
Data Mover 7 (server_7):
Data Mover 8 (server_8):
Data Mover 9 (server_9):
DM NTP Servers
IP addresses of Network Time Protocol servers
❑ ❑
Primary Standby
❑ ❑
Primary Standby
❑ ❑
Primary Standby
❑ ❑
Primary Standby
❑ ❑
Primary Standby
❑ ❑
Primary Standby
❑ ❑
Primary Standby
❑ ❑
Primary Standby
❑ ❑
server_4 server_5
❑ ❑
Auto Retry
❑ ❑
Auto Retry
❑ ❑
Auto Retry
❑ ❑
Auto Retry
❑ ❑
Auto Retry
❑ ❑
Auto Retry
❑ ❑
Auto Retry
❑ ❑
Auto Retry
_____________________________________
_____________________________________
_____________________________________
❑ ❑ ❑
server_6 server_7