Express Install For File Oe Release 7.1 Or Higher - EMC VNX VG2 Setup Manual

Table of Contents

Advertisement

Express Install for File OE Release 7.1 or higher

Figure 134
This version of the Express Install eliminates several user prompts by auto-detecting
the needed values. To install the EMC NAS software on the CS, follow these steps:
Note: Use the Tab key to navigate between fields; press Enter to select values.
1. Insert the EMCNAS installation media into the Control Station, press the power
button off for 5 seconds, then press the button on to reboot the Control Station.
The Control Station displays its boot messages followed by the prompt shown in
Figure 134 on page
217.
2. Type gateway, and then press Enter.
Note: You have one minute to type an installation command; otherwise the system will
look for an existing installation.
After you type the command, the system copies the contents of the media to the
CS, ejects the media, and then restarts the CS.
Install software prompt
3. If prompted to confirm the installation, type yes to continue.
4. If the system displays the prompt shown in
Enter.
EMC CONFIDENTIAL
Figure
135, tab to Yes, and then press

Express Install for File OE Release 7.1 or higher

NAS Install Options
217

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VNX VG2 and is the answer not in the manual?

This manual is also suitable for:

Vnx vg8

Table of Contents