Manual Instructions For Setting The Country Code - EMC VNX VG2 Setup Manual

EMC CONFIDENTIAL
Change ConnectHome Dialing Configuration
Figure 103
Manual instructions
for setting the
country code
Example:
170 EMC VNX VG2/VG8 Gateway Configuration Setup Guide
8. Select or verify the correct country/region is selected (see
page 170). Click Next.
Country/Region wizard screen
A confirmation screen appears with your selection.
9. On the confirmation screen, click Next.
10. Click Finish to exit the wizard. This completes this procedure.
To manually set the country/region code without the ZBAWizard.exe utility:
1. Connect the serial cable from the modem to the service laptop.
Note: Ensure that the modem is powered up.
2. Open a HyperTerminal session by using the following settings: 19200 bits per
second, 8 data bits, parity None, 1 stop bit, flow control None. Typically this is
done by using COM 1.
3. Enter the following command to check the current country/regional setting:
ATI9
The decimal value associated with the country/region code is output to the
HyperTerminal session. Refer to
their decimal values.
+++
ATI9
52
(?$MTS00C1\\MODEM\TIA0602,TIA0578\MultiTech Systems
MT5634ZBA-V92A9)
OK
Table 6 on page 171 for a list of the countries and
Figure 103 on