EMC VNX VG2 Setup Manual page 218

EMC CONFIDENTIAL
NAS Install Options
Figure 135
Figure 136
218 EMC VNX VG2/VG8 Gateway Configuration Setup Guide
Linux Installation prompt
5. At the Confirm Choice prompt, tab to Ok, and then press Enter.
The system detects whether this is a fresh install and whether you are configuring
CS 0 (primary) or CS 1 (secondary).
6. The Primary Internal Network Setup window appears
Control Station internal networking configuration information from the values in
the "Control Station 0 networking worksheet" on page
Note: Unless there is a conflict with the customer's existing network, you should use the
default private LAN IP addresses. If you use other addresses, you must still use the last
octet of the default address. You cannot change the hostname values.
a. In the Primary Internal Network Setup dialog box, enter the IP address and
netmask for the primary internal LAN connection (port A)
accept the default values, tab to Ok and press Enter.
Primary internal network settings
(Figure 136). Enter the
277:
(Figure 136). To