EMC VNX VG2 Setup Manual page 225

The system prompts you to select the number of fibre switches to use
(Figure 149).
Number of Fibre Channel switches screen
Figure 149
17. Enter the number of switches and press Enter.
The system prompts you to enter information for switch 1
Fibre Channel switch 1 settings
Figure 150
18. Enter the Fibre Channel switch information, tab to OK, and press Enter. Get the
FC switch information from the
The system prompts you to enter switch 2 information (similar to
19. If you selected to use more than one FC switch for the new array, the system
prompts you to enter information for the next switch (similar to
the information, tab to Ok, and press Enter. Repeat for each FC switch.
20. If the VNX array has only two frontend ports on each SP, the system prompts you
for confirmation. If you get this prompt, go to
EMC CONFIDENTIAL
"FC/FCoE cabling worksheet" on page
step 23 on page
Express Install for File OE Release 7.1 or higher
NAS Install Options
(Figure 150).
273.
Figure 150).
Figure 150). Enter
227.
225