EMC VNX VG2 Setup Manual page 220

EMC CONFIDENTIAL
NAS Install Options
Figure 139
Figure 140
220 EMC VNX VG2/VG8 Gateway Configuration Setup Guide
7. Enter the Control Station external networking configuration information from the
values in the "Control Station 0 networking worksheet" on page
Note: This is the network connection to the Control Station that is used to remotely
administer the VNX gateway system.
The system displays the Network Configuration dialog box shown in
a. Tab to Yes and then press Enter.
Network Configuration
The system displays the Boot Protocol dialog box shown in
b. Select Static IP address, BOOTP, or DHCP; tab to Ok; and press Enter.
Boot Protocol
If you selected Static IP address, the system displays the Configure TCP/IP
dialog box shown in
Note: If you selected BOOTP or DHCP,
Figure 141 on page 221.
this dialog box is skipped.
277:
Figure 139.
Figure 140.