Step 5: Check System Status; Step 6: Enable Licensed Features - EMC VNX VG2 Setup Manual

Step 5: Check system status

Step 6: Enable licensed features

• If the customer is located in a country that does not use the U.S.-style dial tone,
such as Germany, disable dial tone detection on the CallHome modem.
"Disabling dial tone detection" on page 167
• If the customer has a MT5634ZBA modem (check the label on the bottom of
the modem or on the box that the modem shipped in), you might need to run a
special utility to set the correct country/regional code.
Note: "Setting the country code on the MT5634ZBA modem" on page 168
instructions to set the country/regional code on the MT5634ZBA modem.
Note: Appendix A, "Change ConnectHome Dialing Configuration,"
on changing the CallHome dialing configuration.
10. Click Apply.
Verify each activated delivery method.
11. Select a delivery method from the Test Type drop-down box and click Test. This
action sends a test ConnectHome message to your service provider by using the
delivery message. A message indicates whether the test succeeded or failed.
Repeat this step for each configured delivery method to ensure they are all
correctly configured.
Check the system status:
1. If the VNX gateway system has an FCoE I/O module in boot slot 0 of the blade
enclosures, follow the steps in Primus article emc275740 before continuing.
2. In Unisphere, select your system from the system drop-down list.
3. In the System Information window, confirm that the Status field is OK.
To enable licensed features for your system:
1. Select System > System Information.
2. From the task list, under System, select Manage Licenses.
3. Select the licensed feature to enable.
4. Click Apply.
5. Click OK to confirm that you have a license for this feature and you want to
enable its use.
6. Repeat this procedure for other licensed features you require.
After the license is enabled, you have to restart the management application to see
this change take effect in the user interface.
EMC CONFIDENTIAL
Install and Configure EMC NAS Software
provides more information.
provides
provides information

Step 5: Check system status

143