Site Preparation Worksheet - EMC VNX VG2 Setup Manual

EMC CONFIDENTIAL
Setup Worksheets

Site preparation worksheet

272 EMC VNX VG2/VG8 Gateway Configuration Setup Guide
Before beginning the installation of a VG2/VG8 system, verify that the following site
preparation steps are complete.
provides details:
❑
All components on site
❑
Four power circuits with correct outlets available at cabinet location
❑
Network cables run to cabinet location
❑
Boot array installed and initial configuration complete:
❑
Boot array has at least four unused disks available
❑
Symmetrix boot array (DMX, VMAX, or VMAXe) has been configured with
the required hypervolumes to support the system
❑
Configuration planning complete and all required customer information collected
and recorded, including:
❑
IP addresses, hostnames, netmasks, and default gateway addresses for Control
Station and blades
❑
Usernames and passwords for Fibre Channel (FC) or Fibre Channel over
Ethernet (FCoE) switch and VNX array management programs
❑
CCA complete and approved
❑
CDs for correct EMC NAS software revision available
"Step 2: Confirm site preparation" on page 47