EMC VNX VG2 Setup Manual page 205

9. The Primary Internal Network Setup window appears
Control Station internal networking configuration information from the values in
the "Control Station 0 networking worksheet" on page
Note: Unless there is a conflict with the customer's existing network, you should use the
default private LAN IP addresses. If you use other addresses, you must still use the last
octet of the default address. You cannot change the hostname values.
a. In the Primary Internal Network Setup dialog box, enter the IP address and
netmask for the primary internal LAN connection (port A)
accept the default values, tab to Ok and press Enter.
Primary internal network settings
Figure 113
The system displays the IPMI Network Setup dialog box
page
b. Enter the IP address and netmask for the IPMI connection (CS ports) between
two Control Stations
to Ok, and press Enter.
206).
(Figure 114 on page
EMC CONFIDENTIAL
(Figure
277:
206). To accept the default values, tab
Express Install for File OE release 7.0 or lower
NAS Install Options
113). Enter the
(Figure 113). To
(Figure 114 on
205