Vnx Boot Array Worksheet - EMC VNX VG2 Setup Manual

EMC CONFIDENTIAL
Setup Worksheets

VNX boot array worksheet

276 EMC VNX VG2/VG8 Gateway Configuration Setup Guide
You will need the following information to configure the connection to a VNX boot
array. This information is entered during
.
page 139
Note: Skip this worksheet if you are configuring a Symmetrix array as the boot array.
SP A Management Port IP Address_____________________________
SP B Management Port IP Address_____________________________
Gateway ____________________________________________________
If you use Unisphere to configure the array, you need the following information.
Unisphere Administrator User Name __________________________
Unisphere Administrator Password ____________________________
You need the following information from the VNX array before installation.
Chapter 8, "Configure the boot array,"
information.
Operating-Environment Revision______________________________
Is Write Cache enabled on the VNX array?
❑
Yes
❑
No
Are privileged user accounts on the VNX array enabled?
❑
Yes
❑
No
"Step 2: Install latest File OE on CS 0" on
provides instructions to collect this