Installation - Mitsubishi Electric MELSERVO-JN Series Instruction Manual

2. INSTALLATION

2. INSTALLATION
WARNING
CAUTION
Be sure to ground the servo amplifier to prevent electric shocks.
Carry the products in a suitable way according to their weight.
Stacking in excess of the limited number of product packages is not allowed.
Do not hold the lead of the built-in regenerative resistor, the cables, or the
connectors when carrying the servo amplifier. Otherwise, it may drop.
Install the equipment to incombustibles. Installing it directly or close to
combustibles will lead to a fire.
Install the equipment in a load-bearing place in accordance with this Instruction
Manual.
Do not get on or put heavy load on the equipment to prevent injury.
Use the equipment within the specified environmental condition range. (For details
of the environmental condition, refer to section 1.3.)
Provide an adequate protection to prevent conductive matters like screws or
combustible matters like oil from entering the servo amplifier.
Do not block the intake/exhaust ports of the servo amplifier. Otherwise, a fault may
occur.
Do not subject the servo amplifier to drop impact or shock loads as they are
precision equipment.
Do not install or operate a faulty servo amplifier.
When the product has been stored for an extended period of time, consult
Mitsubishi Electric.
When handling the servo amplifier, be careful about the edged parts such as the
corners of the servo amplifier.
The servo amplifier must be installed in the metal cabinet.
When fumigants that contain halogen materials such as fluorine, chlorine, bromine,
and iodine are used for disinfecting and protecting wooden packaging from insects,
they cause malfunction when entering our products. Please take necessary
precautions to ensure that remaining materials from fumigant do not enter our
products, or treat packaging with methods other than fumigation (heat method).
Additionally, disinfect and protect wood from insects before packing products.
2 - 1