Mitsubishi Electric MELSERVO-JN Series Instruction Manual page 435

13. POSITIONING MODE
No. Symbol
PE22 *LNPL
Position range output address -
Used to set the address decrement side position range output address.
Set the same sign to parameters No. PE22 and No. PE23. Setting of
different signs will result in a parameter error.
Set address:
PE23 *LNPH
Position range output address - is a set of upper digits and lower digits. To
change the value, set in the order of lower digits to upper digits.
PE24 *EOP1 Function selection E-1
Used to permit/inhibit editing the point table/program or to select the polarity
of program input 1 (PI1).
PE25 For manufacturer setting
PE26 Do not change this value by any means.
PE27
PE28
(3) Rough match output
Rough match (CPO) is output when the command remaining distance reaches the value set in parameter
No. PE12 (rough match output range). The setting range is 0 to 65535 [×10
Servo motor
speed
Rough match
(CPO)
Travel completion
(MEND)
Name and function
Upper three digits Lower three digits
Parameter No. PE22
Parameter No. PE23
0 0
Point table/program edit
0: Permit
1: Inhibit
Polarity selection of program input 1 (PI1)
This setting is used only for the program method.
It is not used in the point table method.
0: Positive logic
1: Negative logic
Command remaining distance
( 10
STM
Forward
Travel
rotation distance
0r/min
ON
OFF
ON
OFF
m) set in parameter No. PE12
Actual servo motor speed
13 - 84
Initial Setting
value range
0 -999999
to
999999
0000h Refer to
the name
and
function
filed.
10
4100
0000h
0000h
STM μm].
Unit
×10 STM μm