Mitsubishi Electric MELSERVO-JN Series Instruction Manual page 471

Revision Date *Manual Number
Feb., 2011 SH(NA)030086ENG-B
Section 5.3.3
Section 5.4
Section 5.5
Section 5.6
Section 5.6.1
Section 5.6.2
Section 5.6.3
Section 5.6 to 5.10
Section 5.7
Section 5.7.1
Section 5.8 (2)
Section 5.8 (2) (a)
Section 5.8 (2) (b)
Section 5.8 (3) (b)
Section 5.8 (3) (c)
Section 5.8 (3) (d)
Section 5.9
Section 5.10
Section 5.10.1
Revision
Following contents are added as a status display for
the positioning mode.
Current position
Command position
Command remaining distance
Point table No./Program No.
Step No.
Note 1 and Note 2 are added.
"Drive recorder valid/invalid display" is added.
"Single-step feed" is added to the test operation mode.
Partially added and changed.
"The number of drive recorder record times" is added.
"Point table error" is added to the parameter errors.
Partially added and changed.
"Point table mode" is newly added.
"Point table transition" is newly added.
"Point table mode setting screen sequence" is newly added.
"Operation example" of point table is newly added.
Changed to section 5.7 to 5.11.
POINT is deleted.
"Positioning setting parameters" is added.
"CN1-23" and "CN1-25" are added to the display definition.
Control mode "CP/CL" is added.
Pin No. 23 and 25 are added.
The followings are added.
Proximity dog (DOG)
Automatic/manual selection (MD0)
Temporary stop/restart (TSTP)
Point table No./Program No. selection 1 (DI0)
Point table No./Program No. selection 2 (DI1)
Point table No./Program No. selection 3 (DI2)
Program input 1 (PI1)
Home position return completion (ZP)
Temporary stop (PUS)
Travel completion (MEND)
Rough match (CPO)
Position range output (POT)
Point table No. output 1 (PT0)
Point table No. output 2 (PT1)
Point table No. output 3 (PT2)
Program output 1 (OUT1)
SYNC synchronous output (SOUT)
Partially added.
Partially added.
"Positioning mode" is newly added.
Partially changed.
Caution is partially changed.
POINT is partially added.
Partially changed.