Mitsubishi Electric MELSERVO-JN Series Instruction Manual page 444

13. POSITIONING MODE
(h) Servo motor software forced stop ( h) )
Click the "Software forced stop" button to stop the servo motor rotation immediately. When the
"Software forced stop" button is enabled, the "Start" button cannot be used. Click the "Software forced
stop" button again to make the "Start" button enabled.
(i) Single-step feed window closing ( i) )
Click the "Close" button to cancel the single-step feed mode and close the window.
(j) Switching to normal operation mode
To switch from the test operation mode to the normal operation mode, turn OFF the power of the servo
amplifier.
13 - 93