1. FUNCTIONS AND CONFIGURATION
1.7 Parts identification
Fixed part
(2 places)
Name/Application
Serial number
Main circuit power supply connector (CNP1)
Connect the input power supply/built-in regenerative
resistor/regenerative option/servo motor/earth.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Rating plate
One-touch tuning button (AUTO)
Press this button to perform the one-touch tuning.
Control circuit power supply connector (CNP2)
Connect the control circuit power supply.
Display
The 3-digit, 7-segment LED shows the servo status
and alarm number
Operation section
Used to perform status display, diagnosis, alarm,
point table and parameter setting operations.
MODE
SET
Used to set data.
Used to change the mode.
Used to change the
display or data in each mode.
I/O signal connector (CN1)
Used to connect digital I/O signals.
USB communication connector (CN3)
Connect the personal computer.
Encoder connector (CN2)
Used to connect the servo motor encoder.
1 - 11
Detailed
explanation
Section 3.1
Section 3.3
Section 1.5
Section 6.1
Section 3.1
Section 3.3
Chapter 5
Chapter 5
Section 3.2
Section 3.4
Section 11.4
Section 3.4
Section 11.1