Mitsubishi Electric MELSERVO-JN Series Instruction Manual page 321

12. SERVO MOTOR
12.5.3 Electromagnetic brake characteristics
CAUTION
The characteristics of the electromagnetic brake provided for the servo motor with an electromagnetic brake
are indicated below.
Item
Type (Note 1)
Rated voltage (Note 4)
Power consumption
Coil resistance (Note 6)
Inductance (Note 6)
Brake static friction torque
Release delay time (Note 2)
Braking delay time (Note 2)
Permissible braking work
Brake looseness at servo motor shaft (Note 5)
Brake life (Note 3)
Selection example of surge
absorbers to be used (Note 7, 8)
Note 1. There is no manual release mechanism. Use a 24VDC power supply to release the brake electrically.
2. The value for initial ON gap at 20
3. Brake gap increases as the brake lining wears, but the gap is not adjustable. Therefore, the brake life is indicated as
the number of braking cycles available before the gap adjustment is required.
4. Always prepare the power supply exclusively used for the electromagnetic brake.
5. The above values are typical initial values and not guaranteed values.
6. These values are measured values and not guaranteed values.
7. Select the electromagnetic brake control relay properly, considering the characteristics of the electromagnetic brake
and surge absorber.
8. Manufactured by Nippon Chemi-Con Corporation.
The electromagnetic brake is provided for preventing a drop at power failure or at
servo alarm occurrence during vertical drive, or for holding a shaft at stop. Do not
use it for normal braking (including braking at servo lock).
Before performing the operation, be sure to confirm that the electromagnetic brake
operates properly.
[s] DC off
Per braking
Per hour
Number of
braking cycles
Work per
braking
For the suppressed
voltage 125V
For the suppressed
voltage 350V
(68 ).
Servo motor
053B
[W]at20
[ ] 91.0
[H] 0.088
[N m] 0.32
[oz in] 45.3
[s] 0.03
0.01
[J]
[J]
[degrees]
[times] 20000
[J]
12 - 18
HF-KN series
13B 23B
Spring-loaded safety brake
0
24VDC
-10%
6.3
5.6
56
2.5
20000
5.6
TND20V-680KB
TND10V-221KB
43B
7.9
73.0
0.10
1.3
184
0.03
0.02
22
220
1.2
22