Forced Tough Drive Operation - Mitsubishi Electric MELSERVO-JN Series Instruction Manual

5. DISPLAY AND OPERATION SECTIONS

5.10.5 Forced tough drive operation

The tough drive can be checked in advance by forcing the overload tough drive, even if the servo motor is in
the normal status.
(1) Operation
Press the "SET" button for 2[s] or longer in normal operation to execute the forced tough drive operation.
(2) Status display
Call the status display screen by pressing the "MODE" button in the forced tough drive operation stand-by
status. The status display screen returns to the forced tough drive operation stand-by screen after one
screen cycle. For details of the status display, refer to section 5.3. Note that the status display screen
cannot be changed by the "UP" or the "DOWN" button in the forced tough drive operation mode.
(3) Termination of forced tough drive operation
To end the forced tough drive operation, turn the power off once, or press the "MODE" button to switch to
the next screen and then hold down the "SET" button for 2[s] or longer.
5.11 One-touch tuning
Press the "AUTO" button for 3[s] or longer in the position control mode, the internal speed control mode or
the positioning mode, and then press it again to execute the one-touch tuning.
POINT
Execute forced tough drive operation after ten minutes of normal operation.
POINT
For full information of the one-touch tuning, refer to section 6.1.
5 - 29