Mitsubishi Electric MELSERVO-JN Series Instruction Manual page 258

11. OPTIONS AND PERIPHERAL EQUIPMENT
11. OPTIONS AND PERIPHERAL EQUIPMENT
WARNING
CAUTION
11.1 Cable/connector sets
As the cables and connectors used with this servo, purchase the options indicated in this section.
Before connecting options and peripheral equipment, turn off the power and wait
for 15 minutes or more until the charge lamp turns off. Otherwise, an electric shock
may occur. In addition, always confirm from the front of the servo amplifier whether
the charge lamp is off or not.
Use the specified auxiliary equipment and options. Unspecified ones may lead to a
fault or fire.
POINT
The IP rating indicated for cables and connecters is for a cable or connector
alone. When the cables and connectors are used to connect the servo amplifier
and servo motor, and if the IP rating of the servo amplifier and servo motor are
lower than that of the cable and connector, specifications of the servo amplifier
and servo motor apply.
11 - 1