Mitsubishi Electric MELSERVO-JN Series Instruction Manual page 183

6. GENERAL GAIN ADJUSTMENT
6.1.1 One-touch tuning procedure
Use the following procedure to perform the one-touch tuning.
Startup of system
Shift to the one-touch
tuning mode
Selection of the response
mode
Execution of the one-touch
tuning
START
Operation
END
Refer to "Introduction" in this manual, and start up the
system.
Rotate the servo motor by a command device, etc. (The
one-touch tuning cannot be performed if the servo motor is
not operating.)
Press the "AUTO" button for 3[s] or longer during the
operation. The display changes to "
shifts to the one-touch tuning mode.
Press the "UP" or the "DOWN" button while "
displayed to select the response mode.
Start the one-touch tuning by pressing the "AUTO" button.
When the one-touch tuning is completed normally, the
gain/filter is automatically adjusted.
6 - 2
", and the mode
" is