Installation Of Encoder Cable - Mitsubishi Electric CR750 Series Instruction Manual

5 Preparations and Connection of Equipment
5.2.2.

Installation of encoder cable

The installation method of the encoder cable is shown by controller to be used.
*CR750-D series: " Figure 5-8 Installation of encoder cable (CR750-D series)"
*CR751-D series: " Figure 5-9 Installation of encoder cable (CR751-D series)"
And, the description about the measures against the noise is shown in the figure " Figure 5-13 Example of
noise measures of tracking system".
(1)CR750-D series controller
<CR750-D series controller (rear)>
<CR750-Dシリーズコントローラ(背面)>
Ferrite core (attachment)
フェライトコア（付属品）
Pass twice
2回通し
(2)CR751-D series controller
<CR750-D series controller (front)>
<CR751-Dシリーズコントローラ(前面)>
Within 300mm
Ferrite core (attachment)
フェライトコア（付属品）
Pass twice
2回通し
5-24 Connection of Equipment [D type]
Within 300mm
300mm以内
Encoder cable
エンコーダケーブル
Installation of encoder cable (CR750-D series)
Figure 5-8
300mm以内
Installation of encoder cable (CR751-D series)
Figure 5-9
Within 300mm
300mm以内
25
CNUSR2 connector
CNUSR2コネクタ
Encoder cable
エンコーダケーブル
CNUSR11 connector
CNUSR13コネクタ
CNUSR12 connector
CNUSR13 connector
CNUSR2 connector
CNUSR2コネクタ
1
26
50
25
26
50
1