Overview ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ - Mitsubishi Electric MELSERVO-JN Series Instruction Manual

5. DISPLAY AND OPERATION
5. DISPLAY AND OPERATION SECTIONS
5.1 Overview
MR-JN-A servo amplifier has a display section (3-digit, 7-segment LED), operation section (4 pushbuttons) and
a one-touch tuning button for servo amplifier status display, alarm display, parameter and point table setting,
etc.
The operation section and display data are described below.
MODE Display mode change
upper/lower switching
UP Display/data scrolling
DOWN Display/data scrolling
SET Display/data
determination
Data clear
POINT
Positioning mode is supported by servo amplifier with software version B0 or later.
Decimal LED
AUTO
One-touch tuning button (refer to section 6.1) The
gain/filter is easily adjusted during the operation.
3-digit LED Displays data.
Displays the decimal points, alarm presence/absence, etc.
Lit to indicate the decimal point.
Decimal point
Lit to indicate the negative value.
Blinks to indicate alarm occurrence.
Blinks to indicate the test operation mode.
The symbol in the third digit indicates that the number is
the upper 3 digits of the parameter or the upper 3 digits
of the point table. (If there is no number in the second
digit, the same symbol will be displayed in the second
digit.)
However, when the position data of the point table is
"100000" or higher, or "-100000" or less, a number will
be displayed in the third digit.
Lit decimal point of the first digit indicates the
lower 3 digits of the parameter or the lower 3
digits of the point table.
5 - 1