ABB DressPack IRB 6700 Product Manual page 195

Step 2 - Hose reinforcement funnel
1
2
3
4
5
Product manual - DressPack/SpotPack IRB 6700
3HAC044270-001 Revision: F
4.2.5 Replacing the protection hose IRBDP SW6 UI and IRBDP MH6 UI
Action
Cut the new protection hose (for the front
end) to the length required.
Note
Place the cut on top of a ridge. See A in the
figure!
Use caution and push cables and hoses
into the part of the protection hose.
Make sure that cables and hoses are not
twisted.
Fit the middle jaws in one of the hose rein-
forcement funnel halves.
Note
The side of the hose reinforcement funnel
which has the bigger outer diameter shall
be turned towards the wrist.
Fit the other half and secure the hose rein-
forcement funnel with the hose clamps.
© Copyright 2014-2017 ABB. All rights reserved.
Note
A
xx0300000061
Front end: 950 mm
Best performed in this order:
1 Cables with the biggest connectors
2 Hoses
3 Cables with the smallets connectors.
xx1400000350
xx1400000351
Continues on next page
4 Repair
Continued
195