ABB DressPack IRB 6700 Product Manual page 137

The table below shows technical data for water and air quality:
Parameter
Water quality
Air quality
Required equipment
Equipment, etc
Water and Air unit
Standard toolkit,
DressPack/SpotPack
Reference documents
Document
Circuit diagram - SpotPack
SWC IRC5 M2004
Circuit diagram - SpotPack
SWC IRC5 Design 2014
PROFINET
Installation of Water and air unit
The procedure below details how to install the Water and Air unit on the robot base.
1
2
Product manual - DressPack/SpotPack IRB 6700
3HAC044270-001 Revision: F
Article number
For spare part number
see chapter:
• Spare parts on
page
3HAC17290-7
Document number
3HAC026208-001
3HAC044736-001
Action
DANGER
Turn off all:
• electric power supply
• water pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
Remove the attachment screws securing the
top cover at the base of the robot.
Do not remove the top cover!
Note
Keep the screws! They will be reused when fit-
ting the water and air unit on the top cover.
© Copyright 2014-2017 ABB. All rights reserved.
2.13.1 Installation of Water and air unit
Value
Normal filtered industrial water quality, 80 to
100 mesh.
Use clean air.
When there is excessive condensate, install
a device that will eliminate water, such as a
dryer or water separator (Drain Catch) on the
inlet side of the air filter.
Note
221.
The contents are defined in section
Toolkits, DressPack/SpotPack on page
Note
Valid for all robots without
PROFINET.
Valid for all robots with option 782-
13 Bosch MFDC PROFINET.
Note
xx1300002322
2 Installation
Continued
217.
Continues on next page
137