ABB DressPack IRB 6700 Product Manual page 113

2
3
4
5
6
7
Product manual - DressPack/SpotPack IRB 6700
3HAC044270-001 Revision: F
2.6.4 Fitting the cable packages IRBDP MH6 UI and IRBDP SW6 UI (Lean ID)
Action
Note
This procedure describes how to apply cable
grease on the cable package inside the tube.
Use caution and pull the cable package out
10 to 15 centimeters longer than the final
mounting positition.
Apply grease on the highlighted areas. See
figure!
Use caution and push the cable package
back into the tube and out through the insert
until the area where grease was applied, is
visible and able to reach.
Apply grease on the highlighted area, so that
the cable package inside the tube is covered
with cable grease all the way through. See
figure!
Use caution and push the cable package
back in through the insert and into its
mounting position in the tube.
© Copyright 2014-2017 ABB. All rights reserved.
2 Installation
Note
xx1400000217
xx1400001389
xx1400001390
xx1400001150
Continues on next page
Continued
113