Operation - Ametek Elgar ReFlex Power Operation Manual

ReFlex Power™
LAN C
ONNECTOR
Primary user interface to the ReFlex Power™ system via Ethernet connection
Type: RJ45, CAT 5 compatible; protocol conforms to IEEE 802.3 Ethernet-based LANs
Mating connector: Amphenol Socapex P/N RJF6MN, AMETEK P/N 856-993-07
Wire size: Standard CAT 5e 10/100-Base-T cable
Maximum length: 10 meters (can be extended subject to the environment and cable type).
LAN C
ONNECTOR
Pin
1
2
3
4
5
6
7
8

OPERATION

3.5
The ReFlex Power™ Controller (RFPC) module functions under remote control
through a host controller. The RFPC module serves as a communications portal
between the power supply modules and the remote host controller. All aspects of
operation could be achieved through use of commands that comply with the
requirements of the SCPI Standard 1999 command language. Additional discrete
digital control signals are available for dedicated hardware interface. All
connectors for control are accessible on the front panel.
M380056-01 Rev L
P
INOUT
Name
TX+ Transmit data positive, twisted differential pair with TX-
TX- Transmit data negative, twisted differential pair with TX+
RX+ Receive data positive, twisted differential pair with RX-
NA
NA
RX- Receive data negative, twisted differential pair with RX+
NA
NA
Function
ReFlex Power™ Controller
Signal Level
IEEE 802.3
IEEE 802.3
IEEE 802.3
N/A
N/A
IEEE 802.3
N/A
N/A
3-17