Ametek Elgar ReFlex Power Operation Manual page 282

ReFlex Power™
P
7.2.4
ROGRAMMABLE
The Active Load module can be programmed several variables:
•
•
•
•
•
R
7.2.5
EADBACK
•
•
•
•
•
•
SPECIFICATIONS
7.3
All specifications are valid after a 30-minute warm-up. Modules could be used at
reduced accuracy immediately following power-on. All accuracy specifications
are plus/minus variations around the nominal parameter values, unless otherwise
noted. Unless otherwise specified, requirements apply at the front panel output
terminals, over the entire programming range, and with remote sense connected
to front panel terminals. Performance specifications are valid following calibration
at 25 °C, +/- 5 °C
P
7.3.1
RODUCT
Model
HPAL
LPAL
M380056-01 Rev L
F
UNCTIONS
Input Current
Resistance
Over Power Protection
Over Voltage Protection
Over Current Protection
F
UNCTIONS
Input Current
Input Voltage
Power
Over Power Protection value
Over Voltage Protection value
Over Current Protection value
M
ATRIX
Voltage
Full-Scale
Rating
500V
500V
Current
Full-Scale Power Rating
Rating
30A 750W
15A 375W
Active Loads
Module Width
Triple, 4.2"
Triple, 4.2"
7-7