Table of Contents
Advertisement
ReFlex Power™
14. Send calibration command to make sure that all the DAC counts
15. Send the system error query command to make sure calibration was
16. If there is no error returned at the system error query command then
17. Reset the unit
M380056-01 Rev L
and current values are valid
CAL<n>:INP:CURR:CALC
successful.
SYST:ERR?
save the calibration result with the following command
CAL<n>:UNLOCK "6867"
CAL<n>:STORE
CAL<n>:LOCK
*RST<n>
Active Loads
7-59
Advertisement
Table of Contents
