Ametek Elgar ReFlex Power Operation Manual page 237

DC Power Supplies
1 Enable signal is internally pulled up to +5 V with a 10 K resistor. To enable the module, the signal is
pulled low (<= 0.5 V) with respect to the ENA RTN signal; this may also be accomplished by shorting Pin
1 to Pin 6.
O
PTIONAL
•
AMETEK P/N 5380508-01, 9-pin Loop-back Connector Assembly. Includes a
jumper wire between Pins 1 and 6 to enable the module outputs.
•
AMETEK P/N 5380443-01, Power Module, 9ft. Unterminated Interface Cable
Assembly. Use when interfacing to an external system.
•
AMETEK P/N 5380443-03, Power Module, Right Angle, 9ft. Unterminated
Interface Cable Assembly. Use when interfacing to an external system.
RFP-D2450-2A3-XXXX M
HPDC-450V Mating Connector Kit - AMETEK Part No. 5380271-02, mates with
RFP-D2450-2A3-XXXX, and includes the following for both Interface and DC
Output connectors:
Bill of Material
AMETEK
Item Description
Part No.
Conn, 21P, DSUB,
1 856-214-04
8/20AWG, Male
Contact, F-Volt,
2 856-745-53 3600VRMS, 500C,
Male
Conn, Backshell, 37P,
3 856-247-39
Strt, 2 PC
Conn, 9P, DSUB, 20-
4 856-214-09
24AWG, Crimp, Male
Conn, Backshell, 9P,
5 856-247-10
DSUB, 2 PC
R
ECOMMENDED
Hand crimp: Positronic Industries P/N 9507-0-0-0
Pneumatic crimp: Positronic Industries P/N 9550-0-2
Insertion/extraction: Positronic Industries P/N M81969/1-02
Insertion/extraction: Positronic Industries P/N 4311-0-0-0
6-34
I C
NTERFACE ONNECTOR
ATING
Manufacturer
Qty
Part No.
1 CBC21WA4M1000Z
4 MS4820D-50
1 D37000Z00
1 SD9M1000Z
1 D9000Z00
T (N I
OOLS OT NCLUDED WITH
A
CCESSORIES
C K
ONNECTOR IT
Manufacturer
Positronic Industries
Positronic Industries
Positronic Industries
Positronic Industries
Positronic Industries
M C
ATING ONNECTOR
ReFlex Power™
Suggested Source(s)
Positronic Ind.
http://www.connectpositronic.com/default.cfm
Positronic Ind.
http://www.connectpositronic.com/default.cfm
Positronic Ind.
http://www.connectpositronic.com/default.cfm
Positronic Ind.
http://www.connectpositronic.com/default.cfm
Positronic Ind.
http://www.connectpositronic.com/default.cfm
K )
IT
M380056-01 Rev L