Table of Contents
Advertisement
ReFlex Power™
INSTALLATION
7.4
The ReFlex Power™ Active Load modules have been fully calibrated and tested
prior to shipment; the modules are ready for immediate use upon receipt.
However, when first unpacked, the modules should be inspected to ensure that
no shipping damage has occurred.
I
7.4.1
NITIAL INSPECTION
Perform a visual inspection of the shipping container prior to accepting the
package from the carrier. If damage to the shipping container is evident, a
description of that damage should be noted on the carrier's receipt and signed by
the carrier's driver.
Verify that the proper module and associated accessories have been received.
Perform a visual inspection of the module after it is removed from the shipping
container. Check for shipping damage such as dents, scratches, or distortion of
the enclosure.
If external damage is evident, there may be internal damage as well. Immediately
contact the carrier and file a claim for concealed damage. In addition, the
shipping container and filler material should be saved for inspection. Forward a
report of the damage to the Customer Care Department where an associate will
provide instructions for repair or replacement of the unit.
L
7.4.2
OCATION CONSIDERATIONS
The Active Load modules are designed for use within the ReFlex Power™
Mainframe. Standalone modules could be inserted within any slot of the
Mainframe.
Since the modules are fan–cooled, they require adequate clearance at the air
intake of the front panels so that airflow is not impeded.
A
R
IRFLOW
Provide adequate clearance for adequate air intake through the front
panels and exhaust through the rear.
Ensure that the ambient air temperature at the front panel air intake
does not exceed 55°C.
Install filler panel(s) in any empty slot(s) of the Mainframe.
CAUTION
Inadequate airflow and excessive ambient air temperature
could result in overheating and thermal shutdown.
M380056-01 Rev L
EQUIREMENTS
Active Loads
7-13
Advertisement
Table of Contents
