Table of Contents
Advertisement
DC Power Supplies
12. The DC power supply module should respond with its
S
TANDALONE
1. Connect the output for standalone operation per the section,
2. Connect appropriate instrumentation for measuring the output
3. Perform the power-on verification test per the section, Power-On
4. Turn on the isolation and remote sense relays, turn on the output
5. Measure the output voltage and current with the external
6. Ensure that the actual values of the output parameters are within
7. Query the values of the output parameters with the following
8. Ensure that the readback values of the output parameters are
9. Turn off the output with the following command:
P
ARALLEL
1. Before attempting to verify parallel operation, perform the power-
2. Connect the outputs for parallel operation per the section, Parallel
6-60
identification string. The default settings of the module will not be
affected.
C
ONFIGURATION
Standalone Configuration.
voltage and current, as well as a load.
Check.
converter, and program full-scale voltage and current with the
following commands:
*RST[n]
OUTP[n]:ISOL 1
OUTP[n]:SENS 1
OUTP[n]:STAT 1
SOUR[n]:VOLT <fval>
SOUR[n]:CURR <fval>
instruments.
specifications of the programmed values.
commands:
MEAS[n]:VOLT?
MEAS[n]:CURR?
within specifications of the actual values.
*RST[n]
C
O
ONFIGURATION
on test of the individual modules per the section, Power-On
Check, and then the standalone operation test per section,
Standalone Configuration.
Configuration. Ensure that the outputs and remote sense are
O
C
PERATION
HECK
C
PERATION
HECK
ReFlex Power™
M380056-01 Rev L
Advertisement
Table of Contents
