Table of Contents
Advertisement
ReFlex Power™
RFP-D1016-021-XXXX I
The INTERFACE connector provides terminations for external connections to
isolated digital and analog control signals.
Connector: Positronic Industries P/N SD9M1000Z, AMETEK P/N 856-214-09
Wire size: Maximum gauge 20 AWG (recommended)
RFP-D1016-021-XXXX I
Figure 6-5. RFP-D1016-021-XXXX Interface Connector, Front Panel View, and Wiring Diagram
Table 6-2. RFP-D1016-021-XXXX Interface Connector Pinout
PIN
NAME
1
1
ENA
1
6
ENA-RTN
2
TRIG-OUT
7
TRIG-OUT-RTN
3
TRIG-IN
8
TRIG-IN-RTN
4
RESERVED
9
RESERVED
5
CHAS-GND
1
Enable signal is internally pulled up to +5 V with a 10 K resistor. To enable the module, the signal
is pulled low (<= 0.5 V) with respect to the ENA RTN signal; this may also be accomplished by
shorting Pin 1 to Pin 6.
O
PTIONAL
•
AMETEK P/N 5380508-01, 9-pin Loop-back Connector Assembly. Includes a
jumper wire between Pins 1 and 6 to enable the module outputs.
M380056-01 Rev L
NTERFACE
Crimp contacts: Positronic Industries P/N MC7520D (initially supplied with
connector)
Backshell: Positronic Industries P/N D9000Z00, AMETEK P/N 856-247-10
Maximum length 10 meters (can be extended subject to environment,
cable type, and interface circuits).
NTERFACE
FUNCTION
Input: module output enable
Input: return for ENA signal; connected to Pin-7/8
Output: trigger output signal
Output: return for TRIG-OUT; connected to Pin-6/8
Input: trigger input signal
Input: return for TRIG-IN; connected to Pin-6/7
Shield ground
I
C
NTERFACE
ONNECTOR
C
ONNECTOR
P
INOUT
A
CCESSORIES
DC Power Supplies
SIGNAL LEVEL
TTL logic level
Signal common
TTL logic level
Signal common
TTL logic level
Signal common
Chassis ground
6-25
Advertisement
Table of Contents
