Ametek Elgar ReFlex Power Operation Manual page 216

ReFlex Power™
≤187.2VAC to ≥171.8VAC: linearly derated from 100% to 85% of rated power
≤171.8VAC to ≥153.7VAC: linearly derated from 85% to 75% of rated power
P
OWER
> 0.95 at full output load, >0. 65 at 20% output load, decreasing to >0.3 at
no load
E
FFICIENCY
RFP-D1016-021-XXXX: 78%, minimum at full output power
RFP-D1065-5A1-XXXX: 80%, minimum at full output power
RFP-D2033-030-XXXX: 80%, minimum at full output power
RFP-D2050-020-XXXX: 80%, minimum at full output power
RFP-D2050-025-XXXX: 80%, minimum at full output power
RFP-D2120-8A3-XXXX: 80%, minimum at full output power
RFP-D2450-2A3-XXXX: 80%, minimum at full output power
H -U
OLD
10ms, with dropout of AC input at full output power for 330W, 332W, 990W, 1000W,
and 1035W models.
8ms, with dropout of AC input at full output power for 1250W model.
F
RONT
OUTPUT (LED, green): output enabled and isolation relay closed
POWER (LED, green): input AC/DC power applied to module
FAULT (LED, red): internal abnormal operating condition detected; output disabled
and isolation relay opened
BUS (LED, green): internal bus communication established
I
6.3.6
NPUT
P
ARALLEL
Any module could be a master; adjacent modules to the right (when viewed
from front of Mainframe) of the master would be slaves; multiple groups of
paralleled modules could be present in the same Mainframe; paralleling could
be extended between Mainframes; internal control interface is automatically
configured; outputs must be externally hardwired in parallel; individual modules
could provide full rated output current when paralleled; only like-rated modules
could be paralleled.
RFP-D1016-021-XXXX, RFP-D1065-5A1-XXXX:
RFP-D2033-030-XXXX, RFP-D2050-020-XXXX, RFP-D2050-025-XXXX,
RFP-D2120-8A3-XXXX, RFP-D2450-2A3-XXXX:
M380056-01 Rev L
F
ACTOR
T
P IME
P I
ANEL NDICATORS
/O C
UTPUT ONNECTIONS
G
ROUPING
nine modules could be connected in parallel
six modules could be connected in parallel
DC Power Supplies
6-13