B.5 Applicable Standards - INVT Goodrive 35 Series Operation Manual

Goodrive35 inverters
Maximum motor cable length is determined by the drive's operational factors. Contact the local
representative for the exact maximum lengths when using external EMC filters.

B.5 Applicable standards

The inverter complies with the following standards:
EN ISO 13849-1: 2008
IEC/EN 60204-1: 2006
IEC/EN 62061: 2005
IEC/EN 61800-3: 2004
IEC/EN 61800-5-1: 2007
IEC/EN 61800-5-2: 2007
B.5.1 CE marking
The CE mark is attached to the drive to verify that the drive follows the provisions of the European
Low Voltage and EMC Directives.
B.5.2 Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical equipment used
within the European Union. The EMC product standard (EN 61800-3: 2004) covers requirements
stated for drives. See section EMC regulations
B.6 EMC regulations
EMC product standard (EN 61800-3: 2004) contains the EMC requirements to the inverter.
First environment: domestic environment (includes establishments connected to a low-voltage
network which supplies buildings used for domestic purposes).
Second environment includes establishments connected to a network not directly supplying domestic
premises.
Four categories of the inverter:
Inverter of category C1: inverter of rated voltage less than 1000 V and used in the first environment.
Inverter of category C2: inverter of rated voltage less than 1000 V other than pins, sockets and motion
devices and intended to be installed and commissioned only by a professional electrician when used
in the first environment.
Note: IEC/EN 61800-3 in EMC standard doesn't limit the power distribution of the inverter, but it
defines the usage, installation and commission. The professional electrician has necessary skills in
installing and/or commissioning power drive systems, including their EMC aspects.
Safety of machinery-safety related parts of control systems -
Part 1: general principles for design
Safety of machinery. Electrical equipment of machines. Part
1: General requirements.
Safety of machinery – Functional safety of safety-related
electrical, electronic and programmable electronic control
systems
Adjustable speed electrical power drive systems. Part 3: EMC
requirements and specific test methods
Adjustable speed electrical power drive systems – Part 5-1:
Safety requirements – Electrical, thermal and energy
Adjustable speed electrical power drive systems – Part 5-2:
Safety requirements. Functional.
245
Appendix B Technical data