INVT Goodrive 35 Series Operation Manual page 51

Goodrive35 inverters
the password can be canceled. If P07.00 is not 0 during powering on, then the parameter is protected
by the password. When modify the parameters by serial communication, the function of the password
follows the above rules, too.
Function
Name
code
P00 Group Basic function group
Speed control
P00.00
mode
Run command
P00.01
channel
Detailed instruction of parameters
Note: AM-Asynchronous Motor; SM-Synchronous
Motor; motor parameter autotuning should be
performed on the inverter before vector mode is
adopted.
0: Sensorless vector control mode 0 (apply to AM
and SM)
No need to install encoders. It is suitable in cases
with low frequency, big torque and high speed control
accuracy for accurate speed and torque control.
Relative to mode 1, this mode is more suitable for
medium and small power.
1: Sensorless vector control mode 1 (applying to AM)
No need to install encoders. It is suitable in cases
with high speed control accuracy for accurate speed
and torque control at all power ratings.
2: SVPWM control
No need to install encoders. It can improve the
control accuracy with the advantages of stable
operation, valid low-frequency torque boost and
current vibration suppression and the functions of slip
compensation and voltage adjustment.
3: Close loop vector control
Need to install encoders. It is suitable in cases with
low frequency, high speed control accuracy for
accurate speed and torque control.
Select the run command channel of the inverter.
The control command of the inverter includes:
start-up, stop, forward, reverse, jogging and fault
reset.
0: Keypad running command channel
("LOCAL/REMOT" light off)
Carry out the command control by RUN, STOP/RST
on the keypad.
Set the multi-function key QUICK/JOG to
FWD/REVC shifting function (P07.02=3) to change
44
Function parameters
Default Mod
value ify
◎
2
○
0