Danfoss ADAP-KOOL Drive Programming Manual page 44

3 Parameter Description
0-71 Date Format
Option:
[0] * YYYY-MM-DD
[1] * DD-MM-YYYY
[2] MM/DD/YYYY
3
0-72 Time Format
Option:
[0] * 24 h
[1] 12 h
0-74 DST/Summertime
Option:
[0] * Off
[2] Manual
0-76 DST/Summertime Start
Range:
0 N/A* [0 - 0 N/A]
0-77 DST/Summertime End
Range:
0 N/A* [0 - 0 N/A]
0-79 Clock Fault
Option:
[0] * Disabled
[1] Enabled
0-81 Working Days
Array with 7 elements [0] - [6] displayed below parameter number in display. Press OK and step between elements by means of
the LCP.
Option:
[0] * No
[1] Yes
44
Function:
Sets the date format to be used in the LCP.
Function:
Sets the time format to be used in the LCP.
Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime
enter the start date and end date in par.0-76
End .
Function:
Sets the date and time when summertime/DST starts. The date is programmed in the format se-
Date Format
lected in par.0-71 .
Function:
Sets the date and time when summertime/DST ends. The date is programmed in the format selected
Date Format
in par.0-71 .
Function:
Enables or disables the clock warning, when the clock has not been set or has been reset due to a
power-down and no backup is installed.
Function:
Set for each weekday if it is a working day or a non-working day. First element of the array is
Monday. The working days are used for Timed Actions.
MG.11.N1.02 - VLT ® is a registered Danfoss trademark
®
ADAP-KOOL Drive Programming Guide
DST/Summertime Start and par.0-77
▲
DST/Summertime
▼
and buttons on