Danfoss ADAP-KOOL Drive Programming Manual page 17

®
ADAP-KOOL Drive Programming Guide
Status display III:
This state displays the event and action of the Smart Logic Control. For
further information, see section Smart Logic Control
The Bottom section always shows the state of the frequency converter
in Status mode.
Display Contrast Adjustment
▲
Press [status] and [ ] for darker display
▼
Press [status] and [ ] for brighter display
Indicator lights (LEDs):
If certain threshold values are exceeded, the alarm and/or warning LED lights up. A status and alarm text appear on the control panel.
The On LED is activated when the frequency converter receives power from mains voltage, a DC bus terminal, or an external 24 V supply. At the same
time, the back light is on.
• Green LED/On: Control section is working.
• Yellow LED/Warn.: Indicates a warning.
• Flashing Red LED/Alarm: Indicates an alarm.
.
Top section
Middle section
Bottom section
MG.11.N1.02 - VLT ® is a registered Danfoss trademark
2 How to Programme
2
17