Danfoss ADAP-KOOL Drive Programming Manual page 190

3 Parameter Description
[10] Filter
[11] Drive cooling fan
[12] System health check
[13] Warranty
23-11 Maintenance Action
Option:
3
[1] * Lubricate
[2] Clean
[3] Replace
[4] Inspect/Check
[5] Overhaul
[6] Renew
[7] Check
23-12 Maintenance Time Base
Option:
[0] * Disabled
[1] Running Hours
[2] Operating Hours
[3] Date & Time
23-13 Maintenance Time Interval
Range:
1 h* [1 - 2147483647 h]
190
Function:
Select the action to be associated with the Preventive Maintenance Event.
Function:
Select the time base to be associated with the Preventive Maintenance Event.
Disabled
[0] must be used when disabling the Preventive Maintenance Event.
Running Hours [1] is the number of hours the motor has been running. Running hours are not reset
at power-on. The Maintenance Time Interval
Interval .
Operating Hours
[2] is the number of hours the frequency converter has been running. Operating
hours are not reset at power-on. The
Maintenance Time Interval
23-13 .
Date & Time [3] uses the internal clock. The date and time of the next maintenance occurrence
must be specified in par.23-14 Maintenance Date and Time
Function:
Set the interval associated with the current Preventive Maintenance Event. This parameter is only
used if Running Hours [1] or Operating Hours
The timer is reset from par.23-15 Reset Maintenance Word
Example:
A Preventive Maintenance Event is set up Monday at 8:00. par.23-12
Operating hours Maintenance Time Interval
[2] and par.23-13
Maintenance Event will be indicated the following Monday at 8:00. If this Maintenance Event is not
reset until Tuesday at 9:00, the next occurrence will be the following Tuesday at 9:00.
MG.11.N1.02 - VLT ® is a registered Danfoss trademark
®
ADAP-KOOL Drive Programming Guide
must be specified in par.23-13
Maintenance Time Interval
must be specified in par.
.
[2] is selected in par.23-12 Maintenance Time Base
.
Maintenance Time Base
is 7 x 24 hours=168 hours. Next
Maintenance Time
.
is