Danfoss ADAP-KOOL Drive Programming Manual page 19

®
ADAP-KOOL Drive Programming Guide
Exit Info mode by pressing either [Info], [Back], or [Cancel].
Navigation Keys
The four navigation arrows are used to navigate between the different
choices available in [Quick Menu], [Main Menu] and [Alarm Log].
Use the keys to move the cursor.
[OK] is used for choosing a parameter marked by the cursor and for
enabling the change of a parameter.
Operation Keys for local control are found at the bottom of the control
panel.
[Hand On]
enables control of the frequency converter via the GLCP. [Hand On] also starts the motor, and it is now possible to enter the motor speed data by means
of the arrow keys. The key can be selected as
The following control signals will still be active when [Hand On] is activated:
• [Hand On] - [Off] - [Auto on]
• Reset
• Coasting stop inverse
• Reversing
• Set-up select lsb - Set-up select msb
• Stop command from serial communication
• Quick stop
• DC brake
NB!
External stop signals activated by means of control signals or a serial bus will override a "start" command via the LCP.
[Off]
stops the connected motor. The key can be selected as Enable [1] or Disable [0] via par.0-41
and the [Off] key is inactive the motor can only be stopped by disconnecting the mains supply.
Enable Disable
[1] or [0] via par.0-40
MG.11.N1.02 - VLT ® is a registered Danfoss trademark
[Hand on] Key on LCP
.
[Off] Key on LCP
. If no external stop function is selected
2 How to Programme
2
130BP046.10
19