Danfoss ADAP-KOOL Drive Programming Manual page 21

®
ADAP-KOOL Drive Programming Guide
Indicator lights (LEDs):
• Green LED/On: Indicates if control section is on.
• Yellow LED/Wrn.: Indicates a warning.
• Flashing red LED/Alarm: Indicates an alarm.
Menu key
[Menu] Select one of the following modes:
• Status
• Quick Setup
• Main Menu
Main Menu is used for programming all parameters.
The parameters can be accessed immediately unless a password has been created via par.0-60
o Password Personal Menu Password
, par.0-65
Quick Setup is used to set up the frequency converter using only the most essential parameters.
The parameter values can be changed using the up/down arrows when the value is flashing.
Select Main Menu by pressing the [Menu] key a number of times until the Main Menu LED is lit.
Select the parameter group [xx-__] and press [OK]
Select the parameter [__-xx] and press [OK]
If the parameter is an array parameter select the array number and press [OK]
Select the wanted data value and press [OK]
Navigation Keys [Back] for stepping backwards
Arrow [▼] [▲] keys are used for manoeuvring between parameter groups, parameters and within parameters.
[OK] is used for choosing a parameter marked by the cursor and for enabling the change of a parameter.
Operation Keys
Keys for local control are found at the bottom of the control panel.
[Hand on]enables control of the frequency converter via the LCP. [Hand on] also starts the motor and it is now possible to enter the motor speed data
by means of the arrow keys. The key can be selected as
Access to Personal Menu w/o Password
or par.0-66
Enable Disable
[1] or [0] via par.0-40
MG.11.N1.02 - VLT ® is a registered Danfoss trademark
Illustration 2.3: Alarm display example
Main Menu Password
, par.0-61
.
Illustration 2.4: Display example
Illustration 2.5: Operation keys of the numerical CP (NLCP)
[Hand on] Key on LCP
.
2 How to Programme
2
Access to Main Menu w/
130BP046.10
21