Danfoss ADAP-KOOL Drive Programming Manual page 25

®
ADAP-KOOL Drive Programming Guide
2.1.6 Function Setups
The Function set-up provides quick and easy access to all parameters required for the majority of ADAP-KOOL applications including most VAV and CAV
supply and return fans, cooling tower fans, Primary, Secondary and Condenser Water Pumps and other pump, fan and compressor applications.
How to access Function Set-up - example
How to change the output on "Analog output 42"
Illustration 2.7: Step 1: Turn on the frequency converter
(yellow LED lights)
Illustration 2.8: Step 2: Press the [Quick Menus] button
(Quick Menus choices appear).
Illustration 2.9: Step 3: Use the up/down navigation keys to
scroll down to Function Setups. Press [OK].
Illustration 2.10: Step 4: Function Setups choices appear.
General Settings
Choose 03-1 . Press [OK].
MG.11.N1.02 - VLT ® is a registered Danfoss trademark
Illustration 2.11: Step 5: Use the up/down navigation keys
Analog Outputs
to scroll down to i.e. 03-11
Illustration 2.12: Step 6: Choose parameter 6-50
42 Output
. Press [OK].
Illustration 2.13: Step 7: Use the up/down navigation keys
to select between the different choices. Press [OK].
NB!
For the quickest and easiest setup of the AKD102,
please use the AKD Wizard (see chapter
2 How to Programme
2
. Press [OK].
Terminal
Introduction
)
25