Suzuki SY413 Service Manual page 2498

TABLE C – "AIR BAG" WARNING LAMP FLASHES (Page 2 of 2)
STEP
1 Check "AIR BAG" monitor coupler.
Is it connected diagnosis switch terminal and
ground terminal in "AIR BAG" monitor coupler by
service wire?
2 1) With ignition switch OFF, disconnect SDM.
2) Measure resistance between "A8" terminal of
SDM connector and body ground.
Is resistance 1 kW or more?
Fig. for STEP 2
NOTE:
Upon completion of inspection and repair work, perform the following procedure.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Repeat "AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE" to confirm that the trouble has been
corrected.
ACTION
Special Tool
(A): 09932-76010
YES
Go to Step 2. Remove service wire.
Substitute a known- Repair short from "V" wire
good SDM and re- circuit to ground.
check.
AIR BAG SYSTEM 9J-29
NO